Skip to main content

HWA-Business

General informationโ€‹

About this Manualโ€‹

This manual is written for professional system integrators and PC technicians. It provides information for the installation and use of the Q-HWA-Business. Installation and maintenance should be performed by experienced technicians only.

IMPORT SAFETY NOTICE

The following information relates to the safety of installation and maintenance personnel. Read all instructions before attempting to unpack, install or operate this equipment, especially before connecting the power adapter. Please refer the Safety Instruction Guide when installing this equipment.

Qiata FTA Business

Hardware Configurationโ€‹

HardwareDescription
CPUIntelยฎ CoreTM i3-7100
Memory4 GB DDR4
HDD480 GB 2.5โ€ SSD, 64 GB mSATA
Extensions1x Modul, 1x PCI-E-Slot
LCD Module2 x 20@x M character LCD
Form Factor1U 19โ€ Rackmount
Dimensions (W x D x H)431 mm, 321 mm, 44 mm
Net Weight7.5 kg
Power12 V โ€“ 3.3 A
Power Supply Input Voltage Range100 VAC โ€“ 240 VAC
Power Supply Frequency50 Hz โ€“ 60 Hz
Power Supply Watts220W ATX Single PSU
Storage Temperature-20ยฐC โ€“ +75ยฐC
Operation Temperature0ยฐC โ€“ 40ยฐC
Relative Humidity5% โ€“ 95%, non-condensing
CertificationsCE Class A, FCC Class A, UL, RoHS

Setting up your Q-HWA-Businessโ€‹

This chapter describes the procedure used to install your Q-HWA-Business and perform the initial configuration.

Inspecting the Packageโ€‹

The appliance package should contain the following items:

  • One Q-HWA-Business Security Appliance
  • One power cable
  • One Ethernet standard cable (colored GREY )
  • One serial cable (console)
  • 19โ€ Rack-Mount kit
  • SDR-Stick including SDR-Documentation
  • One Quick Start Guide
caution

If an item is missing, please contact your dealer.

Importantโ€‹

  • A crossover cable should be used when connecting the Appliance directly to another machine.
  • A standard Ethernet cable should be used when connecting the Appliance to a network hub, switch or modem.

Powering Up the Q-HWA-Businessโ€‹

  1. Connect and power on the Appliance. After a few seconds the Status LED starts to blink.
  2. Wait until the Status LED indicates constant GREEN: Booting procedure is finished

Powering Down the Q-HWA-Businessโ€‹

caution

You must shutdown the system before switching off the power to the Appliance! You can do this via the WebUI.

  1. At the beginning of the shutdown procedure the status LED will start to blink.
  2. The status LED will switch to RED at the end of the shutdown procedure.

Connect the Appliance to your networkโ€‹

Default Configurationโ€‹

The Management-port is pre-configured to 192.168.2.1. You can change this IP address using the WebUI or on the console using the tool DomosNetConf.

Default Network Configurationโ€‹

InterfaceIP AddressNetmask
port1192.168.2.1255.255.255.0

All other Ethernet connectors are not configured. Further information and documentation can be found in the DOMOS hardware documentation.